Sequence details

Sequence details is a supplimentary component for a Sequence overview widget that is used to show sequence content without zooming. Every time you double click the sequence in a Sequence Overview widget or select an annotation the corresponding sequence position is made visible in the Sequence details widget.

For a DNA sequences Sequence details automatically shows complement DNA strand and 6 amino translation frames.

You can turn off translation or complement strand visualization by using toggle buttons on sequence toolbar.

The default value for genetic code is read by UGENE from the sequence file when available. You can always adjust it using genetic code selection button.
Note: All analysis routines (like HMMER, OFR finding, etc..) will use this code by default.

The default value for genetic code is read by UGENE from the sequence file when available. You can always adjust it using genetic code selection button.
Note: All analysis routines (like HMMER, OFR finding, etc..) will use this code by default.

Sequence manipulation

The selected sequence region or its amino translation can be copied into the clipboard by pressing special buttons in the global toolbar or by using the following shortcuts:

• Ctrl+C - copies direct sequence strand
• Ctrl+T - copies direct amino translation
• Ctrl+Shift+C - copies reverse-complement sequence
• Ctrl+Shift+T - copies reverse-complement amino translation

There are also special buttons to copy sequence or sequence translation under the selected annotation:

Annotations editor >>